Installation and adjustment for forklift distributor

- Dec 01, 2020-

The distributor assy is installs on the forklift engine parts, in the ignition system,it plays 

the role as distribute high votage.

Below are the few  essential steps for installantion and assembe adjustment:

1. You can start to carried out in the reverse order of disassembly before assemble.

2.Each parts of the distributor should be clean and a small amount of lubricating grease shall be applied on the friction surface of each relative movement for lubrication.

3. After installation, rotating distributor shaft should be flexible without jamming,

There should be no obvious sense of clearance when the distributor is pushed and pulled 

axially. Otherwise, it can be adjusted by changing the thickness of the adjusting gasket.